Device Installation; Installation Rules - Atlantic MARADJA Manual De Instalación Y Funcionamiento

Thank you for having chosen this device and placing your confidence in us. The radiator you have just
acquired has been vigorously tested and inspected in order to insure the best quality and provide you with
complete satisfaction.
n
Some Advice:
Read the Guide before starting installation in order to comply with regulatory requirements. Check the supply
u
voltage and turn off the electricity before connecting the device.
n
Keep this Guide, even after installing the device.
Device characteristics:
s.
CAT C : This device complies with NF Electricity Standard performance in the indicated category.
le
IP24 : This device is protected against water spray
Class II : Double insulation (no ground).
IK08 : Impact strength
: This device complies with European Directive 2002/96/CE (WEEE).
ée).

1 - Device Installation

Your device comes with its wall bracket and mounting screws. The choice of screws and anchors depends on
your wall type, so you must ensure that you are using the appropriate screws and anchors based on device
weight.
To facilitate installation, this device has been designed to stand up during connection and bracket installation.
Once the device is standing, you may remove the wall bracket to be used as a template for drilling the holes.
ous

1 .1 - Installation Rules

e à
This device has been designed to be installed in a residential area.
Installation must comply with good practice and applicable standards
in the country where it is installed (NFC 15100 for France).
Observe minimal distances from furniture when placing the device (see
diagram).
If you have a wall covering over foam you must place a shim under the
device support of an equal thickness to the foam in order to maintain
the free space behind the device and not hinder its operation.
Do not install the device:
- In an air fl ow which may hinder operation (under a controlled
mechanical ventilation, etc.)
- Under a power socket.
- In bathroom volume 1.
ée
Devices used in bathrooms must be installed such that the switches
une
and other control systems may not be touched by a person in the bath
ans
or shower.
1.2 - Attach the Wall Bracket to the Wall
- Place the wall support on the ground.
- Identify drilling points A. These are the lower attachment points.
- Place the wall bracket with the previously identified points
coinciding with the drilling holes A.
- Mark both drilling points B with a pen. You have now identified
the 4 drilling points.
- Drill the 4 holes and insert the appropriate anchors for your wall
type (for example : plasterboard, concrete).
- Position the wall bracket and screw in place.
431396J_maradja_international.indd 11 11/06/10 11:10