Tip Prevention – Securing the TV to the Wall
To Avoid the TV from Falling
1. Put the screws into the clamps and firmly fasten them onto the wall. Confirm that the screws have been firmly
installed onto the wall.
✎
You may need additional material such as an anchor depending on the type of wall.
✎
Since the necessary clamps, screws, and string are not supplied, please purchase these additionally.
2. Remove the screws from the back centre of the TV, put the screws into the clamps, and then fasten the screws onto
the TV again.
✎
Screws may not be supplied with the product. In this case, please purchase the screws of the following
specifications.
✎
Screw Specifications
•
For a 51 ~ 60 inches: M8
3. Connect the clamps fixed onto the TV and the clamps fixed onto the wall with
a strong cable and then tie the string tightly.
✎
NOTE
− Install the TV near to the wall so that it does not fall backwards.
− It is safe to connect the string so that the clamps fixed on the wall are
equal to or lower than the clamps fixed on the TV.
− Untie the string before moving the TV.
4. Verify all connections are properly secured. Periodically check the connections
for any sign of fatigue or failure. If you have any doubt about the security of
your connections, contact a professional installer.
[PF5500-TK]BN68-04885B-06L04.indb 23
Caution: Pulling, pushing, or climbing on the TV may cause the TV to fall. In
particular, ensure your children do not hang on or destabilize the TV. Doing
so may cause the TV to tip over, causing serious injuries or death. Follow all
safety precautions provided in the Safety Flyer included with your TV. For
added stability and safety, you can purchase and install the anti-fall device
as described below.
English - 23
Wall
2013-11-13
4:24:40