Reconnecting the Smart Touch Control
Battery Low Alarm
Inserting the Batteries (AAA X 2)
1. Slightly lift the battery cover using a plastic card. Next, pull on the cover's notch with a fingernail to remove the cover
completely.
✎
Check the location of the battery cover groove. The groove's location may vary depending on the type of
Smart Touch Control is provided with the product.
2. Insert 2 AAA batteries, making sure to align the positive and negative ends correctly.
3. Align the battery cover with the back of the remote control and press down along the edges until it is cleanly
attached to the remote control.
Using the touchpad
Use the touchpad to perform various commands. Navigate to Tutorial (Screen Menu > System > Device Manager >
Smart Touch Control Settings > Tutorial) to view an on-screen guide to using the Smart Touch Control.
Drag on the touchpad in the desired direction.
Move the focus or the pointer in the direction the finger is dragging.
[PF5500-TK]BN68-04885B-06L04.indb 7
<The Smart Touch Control's pairing button>
If the Smart Touch Control stops operating or works abnormally, replace the battery as this may be caused by
insufficient battery power. If the problem persists, press the
restore pairing with the TV. The
PAIRING
battery cover. Within a distance between 30cm to 4m, point the Smart Touch Control to the TV receiver and press
the
PAIRING
button. When pairing is complete, the pairing image displays at the bottom left of the TV screen.
If the battery becomes and blanks low while using the Smart Touch Control, the following alarm
window blinks and appears at the bottom left of the screen. If the alarm window pops up, replace
the batteries of the Smart Touch Control. Use alkaline batteries for longer usage.
1
Dragging
PAIRING
button on the Smart Touch Control to
button cannot be accessed without removing the Smart Touch Control's
3
2
Press the touchpad. This selects the focused item.
English - 7
Press
2013-11-13
4:24:35