Rola RBE Instrucciones página 7

INSTALLATION INSTRUCTIONS
1. Remove RE cross bars from the carton.
Slide out the outer under-­cover strips.
Fig. A.
2. Slide the positioning slider inward. The slider
will be positioned after the cross bar
assembly is on the vehicle. Fig. B.
3. Unlock and open the locking cover. Loosen
the tightening bolt with the "T" wrench (C)
until strap is fully open. Repeat on all the RBE
end supports as shown in. Fig. C.
Fig. C
C
PAGE 7
Outer under-­cover strips
Fig. B
Slide
Fully opened
59974N Rev A • Questions? (800) 234-­6992 • ROLAProducts.com
End tab