Rola RBE Instrucciones página 8

INSTALLATION INSTRUCTIONS
4. Slide the RBE end supports into the rails and leave loose until set into place on the vehicle's side
rails. Fig. D.
Fig. D
5. Carefully position the cross bars onto the vehicle side rails using measurements "Y" & "Z".
Fig. E. Once on the car, position the cross bars to have equal amounts of overhang per side,
"X", after pushing the end support against the vehicle's rail. Fig. F.
X
Roof
Fig. E
Fig. F
Lower over rail.
Tip: place bar upside down
for easier handling of parts
Y
Y
1
Z
X
Rail
2
Then push against rail.
PAGE 8 59974N Rev A • Questions? (800) 234-­6992 • ROLAProducts.com