Maintenance Information For Miranit-S; Important - Franke AQCT0029 Instrucciones De Montaje Y Uso

Removing the shower panel
For some maintenance tasks, the shower panel must be removed.
Caution!
Do not allow the shower panel to hang by the connecting hoses.
Water connection from above:
19.1 Close the water volume regulators.
a: closed
b: open
19.2 Disconnect the fitting.
19.3 Disconnect the water supply.
19.4 Undo the screws on the shower panel.
19.5 Take down the shower panel.
19.6 Insert the side of the shower panel into the suspension rail.
Water connection from rear:
19.7 Undo the screw on the shower panel.
19.8 Detach the shower panel.
19.9 Insert the side of the shower panel into the suspension rail.
19.10 Close the water volume regulators (see
19.11 Disconnect the fitting.
19.12 Disconnect the water supply.

20. Maintenance information for MIRANIT-S

Soap cleaners with a neutral pH-value are sufficient for cleaning and care. Apply the
cleaner with a soft, clean cloth, leave to soak briefly and then rinse with lots of water.
Caution!
The following may not be used:
• Cleaning agents with an abrasive effect
• Cleaning sponges / cleaning cloths with an abrasive effect
• Steel wool or other hard objects
• Solvents
☞

Important!

Any minor damage to the surface, e.g. small scratches, can be directly polished out.
A repair kit is available for larger damaged areas. The surface is adjusted with Type
1000 grinding paper after application and drying of the repair material.
step 19.1).
11