Duschmeister TRI Manual De Utilización E Instalación página 26

TROUBLESHOOTING
Problems
Encountered
The device does not
heat
The device heats all
the time
The surface of the
device is very hot.
The last elements,
top and bottom, are
colder than the rest
of the device. It is
normal.
The device does not
follow
programming
instructions
- Ensure that the device is correctly supplied.
- Check the air temperature in the room.
- Check that the device is not located in a draft or
that the temperature setting has not been changed.
- There may be a fluctuation in the electricity supply.
If you experience a problem (thermostat locked, ...),
take out the plug for approx. 10 minutes and then
plug
- If this occurs frequently, have your power supply
checked by your local power supplier.
It is normal for the device to be hot when it is
operating; the maximum surface temperature is
limited in accordance with the prevailing standard.
If nevertheless you think your device is always too
hot, check that the output is suitable for the size of
your room (we recommend 50W/cubic meter) and
that the device is not located in a draft interfering
with its automatic controls.
TOP ELEMENTS are not completely filled to allow
the expansion of the thermodynamic fluid. They
heat
BOTTOM ELEMENTS channel the returning fluid
after it has transmitted its heat.
Ensure to have correctly followed all the instructions
(please refer to the User's Manual).
the
What to do
it
up only
25
in again.
by conduction.