Sauder Pacific View 427035 Instrucciones De Montaje página 2

Table of Contents
Part Identification
Hardware Identification
Assembly Steps
Français
Español
Safety
Warranty
Part Identification
å
While not all parts are labeled, some of the parts will have a label or an inked letter on the edge
to help distinguish similar parts from each other. Use this part identification to help identify similar parts.
A RIGHT PEDESTAL END (1)
B LEFT PEDESTAL END (1)
B55 PENCIL DRAWER BOTTOM (1)
C DESK TOP (1)
D RETURN TOP (1)
D28 FILE RIGHT DRAWER SIDE (1)
D29 FILE LEFT DRAWER SIDE (1)
D78 FILE DRAWER BACK (1)
D266 PENCIL RIGHT DRAWER SIDE (1)
D267 PENCIL LEFT DRAWER SIDE (1)
D563 PENCIL DRAWER BOX FRONT (1)
D564 PENCIL DRAWER BACK (1)
D707 FILE DRAWER BOTTOM (1)
Page 2
Assembly Tools Required
2-3
4-5
6-51
52-57
58-64
65-66
67
E RETURN RIGHT END (1)
F RETURN MODESTY PANEL (1)
G DESK MODESTY PANEL (1)
H FILE DRAWER FRONT (1)
J PEDESTAL BOTTOM (1)
K RETURN SIDE MOLDING (2)
L PEDESTAL END MOLDING (3)
M FRONT BOTTOM MOLDING (1)
N FRONT TOP MOLDING (1)
O FRONT RETURN MOLDING (1)
P DRAWER MOUNT (2)
Q ADJUSTABLE SHELF (1)
R SHELF (1)
No. 2 Phillips Screwdriver
Tip Shown Actual Size
Hammer
Not actual size
S LARGE SUPPORT PANEL (1)
T SMALL SUPPORT PANEL (1)
U RIGHT FRONT/LEFT REAR LEG (2)
V LEFT FRONT/RIGHT REAR LEG (2)
W RIGHT FRONT PEDESTAL LEG (1)
X RIGHT REAR PEDESTAL LEG (1)
Y BACK (1)
Z PENCIL DRAWER FRONT (1)
AA BACK TOP MOLDING (1)
BB BACK RETURN MOLDING (1)
CC SHELF MOLDING (1)