Sauder Pacific View 427035 Instrucciones De Montaje página 25

Step 19
å
Push four HIDDEN CAMS (1F) into the SHELF (R). Then, insert the metal end of a CAM
DOWEL (2F) into each HIDDEN CAM.
å
Slide the SHELF MOLDING* (CC) onto the notched edge of the SHELF (R).
å
NOTE: The SHELF MOLDING (CC) is smaller than the FRONT BOTTOM MOLDING (M).
å
*U.S. Patent No. 5,499,886
Do not tighten the HIDDEN CAMS in this step.
Arrow
2F
Metal end
1F
R
Notched edge
Slide the MOLDING (CC)
onto the notched edge.
1F
CC
These surfaces
should be even.
Arrow
Metal end
2F
The groove
is closer to
this edge.
Page 25