Starting Operation - marklin 60652 Manual De Instrucciones

Possible Uses for the Mobile Station
60652 individual controller, controller from 1 Gauge starter sets:
Suitable for Märklin H0 and 1 Gauge.
Maximum output current: 1.9 amps (with 60052 Transformer).
Connections only by means of special connector box.
Number on the base of the controller: "60651" (!)
Controller from Märklin H0 starter sets:
Suitable for Märklin H0.
Maximum output current: 1.2 amps (with 60052 Transformer).
Connections only by means of special connector box.
Number on the base of the controller: "60652".
The output current is sufficient for 2 – 3 locomotives in operation.
The number of locomotives that can be run may be lower due to
cars with interior lighting, smoke generators that are on, sound
effects modules that are on, etc. The Central Station is the
suitable operating system for layouts with several users. The
Mobile Station can be used here as a locomotive controller.
Connections for the Mobile Station
1. Check to make sure that the power cord(s) for the layout are
unplugged from the wall outlet.
2. Check to make sure that the
transformer or the power
pack is the right one for
your household electrical
current (value of the input
voltage, value of the fre-
quency). This information
can be found on the spe-
cification plate for the trans-
former / power pack.
3. Plug in the Mobile Station. The first Mobile Station must be
connected to the left 10-pin socket on the connector box.
4. Connect the transformer or power pack to the connector box.
(=> Appendix A)

Starting Operation

Mobile Station after the power cord for the power pack / trans-
former is plugged into the wall outlet:
1. Short phase while the system is being turned on ("MÄRKLIN"
appears in the display).
2. Mobile Station switches directly to the operation mode.
(=> Appendix B)
On the Mobile Station the locomotives to be controlled are
selected from a locomotive list. Since the Mobile Station comes
10
from the factory with no entries in the locomotive list, the display
goes directly to the entry of locomotives into the locomotive list.
("NEW LOC"). The Mobile Station that comes with the starter sets
comes from the factory with entries already in its locomotive list.
Putting a Locomotive into the Locomotive List
Possibility A: mfx locomotives automatically register themselves.
Possibility B: The locomotive is taken from the database.
Possibility C: The locomotive is entered by means of its address.
Possibility A:
Place a locomotive with a built-in mfx decoder on the track before
turning the layout on. During the period in which the system is
turning itself on, the mfx locomotive transfers its data to the
Mobile Station. As soon as the Mobile Station is ready for ope-
ration, this locomotive can be selected from the locomotive list.
(=> Appendix C)
Important: If the locomotive list has 10 entries, then no other
locomotive can be placed into the locomotive list. In this situation
one entry must be deleted (=> Page 12) and then the mfx loco-
motive can be registered again.
Possibility B:
1. Press the Menu/ESC button.
2. Turn the speed control knob until "NEW LOC" appears
in the display.
3. Press on the speed control knob.
4. Turn the speed control knob until "DATABASE" appears
in the display.
5. Press on the speed control knob.
6. Turn the speed control knob until the item number for the
locomotive appears in the display.
7. Press the Locomotive/OK button. The display will change
back on its own to the operating level.
(=> Appendix D)
Possibility C:
1. Press the Menu/ESC button .
2. Turn the speed control knob until "NEW LOC" appears
in the display.
3. Press on the speed control knob.
4. Turn the speed control knob until "ADDRESS" appears
in the display.
5. Press on the speed control knob.