marklin 60652 Manual De Instrucciones página 11

6. Turn the speed control knob until the address for the loco-
motive appears in the display.
7. Press on the speed control knob.
8. Turn the speed control knob until the desired symbol appears
in the display.
9. Press the Locomotive/OK button. The display will change
back on its own to the operating level.
(=> Appendix E)
Tip: The address or the name in the display can be changed for
all entries in the locomotive list (Page 11/12). This means that
you can change entries from the database for other applications.
Controlling the Locomotive
Turn the speed control knob to the right
– the locomotive goes faster.
Turn the speed control knob to the left
– the locomotive goes slower.
The bar in the speed indicator changes with the new speed
that has been set.
Press on the speed control knob – the direction of travel changes.
At the same time the direction of travel indicator and the
direction of the bar in the speed indicator changes.
Pressing auxiliary function buttons
– the function assigned to that button is turned on.
Please Note:
The auxiliary functions (if they are present in the locomotive)
for locomotives from the database are shown as a graphic
symbol in the display. Only these functions can be turned on.
Headlights are mostly turned on with the separate headlight
button.
Locomotives that are set up in the locomotive list with an
address have no graphic symbol in the display. In this situation
the headlight button is used for the auxiliary function "function"
and the 4 auxiliary function buttons to the left of the display
are used for the auxiliary functions f1, f2, f3, and f4 (from top
to bottom).
Changing the Locomotive
1. Press the LOCOMOTIVE/OK button.
2. Turn the speed control knob until the desired locomotive
appears in the display.
3. Press the LOCOMOTIVE/OK button.
(=> Appendix F)
Now the newly selected locomotive can be controlled. The last
locomotive called up before th is will continue to run with the last
operating commands sent to it!
Emergency Stop
Press the STOP button: The power is not off to the layout.
All locomotives and trains will come to a halt. "STOP" will appear
in the display.
Pressing the Stop button again will turn the power to the layout
on again.
Important: When there is a short circuit or when the system is
overloaded, the system switches to the STOP status on its own.
Correct the problem in this case and try to resume operation by
pressing the Stop button. If the system shuts down again, then
the problem has not been corrected yet!
Changing Locomotive Data
Requirement:
The locomotive has been entered into the locomotive list.
For locomotives with the address set by means of the Mobile
Station: Only this locomotive may be in the area controlled and
powered by the Mobile Station.
No change of address is required for locomotives with an
mfx decoder. As such, this setting option is not available
for these products.
Changing the Address
1. Stop the locomotive.
2. Press the Menu/ESC button.
3. Turn the speed control knob until "EDIT LOC" appears
in the display.
4. Press on the speed control knob.
5. Turn the speed control knob until "ADDRESS" appears
in the display.
6. Press on the speed control knob.
7. Turn the speed control knob until the new desired address
for the locomotive appears in the display.
8. Press on the speed control knob.
On locomotives with coding switches, the new desired address
must be set on the decoder.
(=> Appendix G)
The following only applies to locomotives, whose address can
be set with the Mobile Station:
9. The question "PROG LOC?" will appear in the display. Press
the Menu/ESC button: The address is only changed in the
locomotive entry. Press on the speed control knob: The loco-
motive address is changed according to the data transmission.
(=> Appendix H)
11