Making Hot Water - ECG ESP 20501 Iron Manual De Instrucciones

4. Put the steam nozzle in the milk about two centimeters below the surface. Press the "steam" button and
turn the knob to steam position, the steam nozzle starts emiting steam. Froth the milk by moving the
kettle around and up / down.
5. When done, turn the knob to neutral position.
Note: When the steaming stops, carefully clean the nozzle using a wet cloth or a sponge. Be careful, do not
damage the nozzle! Be careful, the nozzle is hot.
6. Pour frothed milk into the prepared espresso, now the cappuccino is ready. Enjoy your coffee! For diversity,
you can sprinkle the foam with a small amount of cocoa.
7. If you no longer use the coffee machine, switch it off and unplug it.
NOTICE:
The water temperature in the boiler is too high after using the "steam" function for making coffee.
If you want to make coffee, we recommend that you first drain the overheated water from the boiler.
Turn the knob to hot water without pressing any button and let the water run out of the nozzle until the
pump stops by itself. Return the knob to neutral position. Now you can make another coffee.
If you no longer want to make more coffee, press the button for one or two coffees to cancel the flashing of
the buttons.
Note: Hot steam can also be used to heat beverages such as hot chocolate.
Note: If the appliance overheats, the indicators on the coffee machine will start to flash quickly. In this case, the
appliance must be cooled by draining the hot water, see above.

Making hot water

After preheating, turn the knob to the Hot Water position without pressing any button.
When you are not using the coffee machine, return the selector lever to the neutral position, switch it off with
the on / off button and unplug it.
Setting coffee size
By default, the volume of one espresso is set to the standard size. The machine allows you to adjust the volume
when preparing one cup in the range from 25 to 60 ml and from 70 to 110 ml in the case of two cups.
1. Plug in the appliance and press the power switch to turn it on. The appliance beeps and the indicators on
the control panel start flashing, indicating that the appliance is heating up.
2. After preheating, press and hold the button for the number of cups whose volume you want to adjust for
at least 3 seconds. The appliance will go to the volume setting mode (on/off indicators and
be lit continually, while other indicators shut off )
3. Press the button or
4. When the desired amount of coffee is in the cup, press the button again. The coffee brewing stops and the
required volume is saved.
Auto shut-off mode
• If you do not perform any operation within 29 minutes after pressing the power button, the unit will turn
off automatically.
• If no operation is performed after pressing the power button after the pump has pumped about 215 ml of
water, the pump will stop automatically.
• After pressing the power button, if no operation is performed after the pump has been running for 180 s
while frothing the milk, the pump will stop automatically.
Tips for making good coffee
The following factors can affect the final quality and taste of coffee:
once more. The appliance starts dispensing the coffee
or will
13