Troubleshooting - ECG ESP 20501 Iron Manual De Instrucciones

Insert the lever with filter WITHOUT COFFEE into the steam head and secure. Leave the lever in the
3.
appliance throughout the descaling process.
4. Press the two cups button (
prepared container. Then switch the machine to "hot water" mode and pump approx. 100 ml of solution
through a nozzle into a prepared container. Allow the solution act for about 5 minutes. Repeat the step 3x.
5. Then fill the tank with clean water to the MAX line and repeat step 4 (alternating rinsing through the cup
and nozzle) at least twice. In this case, it is not necessary to observe the 5-minute interval between cycles.

TROUBLESHOOTING

Problem
Water leak from the bottom of
the machine.
Water leak from the side of
the filter.
The espresso tastes sour
(vinegary).
The coffee machine does not
work.
Steam frothing is failing.
Fast flashing one cup indicator
and two cup indicator
Fast flashing steam indicator
All indicators flash quickly 5
times in succession
Immediately after switching
on the machine, all icons
flash quickly and the machine
beeps.
16
). Allow the solution to flow freely through the metal cup into a pre-
Cause
There is too much water in the drip
tray.
The machine does not work.
There are remains of coffee grounds
on the edge of the filter.
The descaling agent has not been
entirely removed after cleaning of
the mineral deposits.
Ground coffee was stored for a
long time in a warm and humid
environment. Ground coffee has
spoiled.
The power cable is not plugged
correctly.
The operation indicator did not
light up.
The kettle used is too large or its
shape does not fit.
You used skimmed milk.
The water in the boiler is too hot.
The selector lever was not turned
back to neutral (OFF) after the unit
cooled down.
The selector lever was not turned
back to neutral position (OFF).
The coffee machine needs to be
descaled
The selector lever was not turned
back to the neutral position (OFF)
before the machine was turned off.
Correction
Clean the drip tray.
Please, contact an authorized service
center.
Remove the coffee remains.
Repeat the procedure described in
the section "When using for the first
time" several times.
Use fresh ground coffee and store
unused coffee in a dry and cool
place. After opening the ground
coffee package, close it tightly and
store it in the refrigerator to keep the
coffee fresh.
Plug in the power cable correctly.
If the appliance still does not work,
please contact an authorized service
center.
The steam is only ready for foaming
when the operation indicator (white)
lights up.
Use a tall, narrow kettle.
Use whole or half-skimmed milk.
Allow approx. 215 ml of water to
flow through the nozzle, see chapter
Frothing milk / making cappuccino.
Turn the selector lever to neutral
position (OFF).
Turn the selector lever back to the
neutral position (OFF).
Carry out descaling according to the
instructions in the chapter "Cleaning
of mineral deposits".
Turn the selector lever to neutral
position (OFF).