CAUTION
USE ONLY AS INTENDED.
Inspect regularly. STOP using if product is damaged or has loose parts.
Only repair with orangebox factory authorized parts and methods.
For information on furniture maintenance, or to report furniture which
requires service, call orangebox at 1.866.232.2149.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY
Please be aware, the door can be a potential finger trap.
Caution must be taken when entering and leaving the
phone booth. Although the door is reinforced, care
should be taken not to obstruct or allow the door to hit
objects when opening and closing
CAUTION UNITS ARE HEAVY.
QT01 and QT02 = 243kg (without furniture)
QT03 and QT04 = 266kg (without furniture)
For Indoor use only in a commercial environment.
Operating temperature 10-26 degrees Celsius.
orangebox.com
This product complies with the EMC, Low Voltage and
RoHS directives, IEC 62368-1:2014, EN 62368-1:2014,
UL 62368-1:2014, CSA C22.2 No. 62368-1-14 and AS/
NZS 62368-1:2018
Locate Declarations of Conformity at
EN: https://www.steelcase.com/eu-en/resources/documents/on-the-qt-eu-declaration-conformity/
FR: https://www.steelcase.com/eu-fr/ressources/documents/declaration-conformite-ue-on-the-qt/
DE: https://www.steelcase.com/eu-de/unterlagen/dokumente/on-the-qt-eg-konformitatserklarung/
This equipment has been tested and found to comply with the limits for
a class B digital device pursuant to Part 15 for FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet or a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to
operate the equipment.