Osram SYLVANIA xenarc X2010 Manual Del Usuario página 6

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Kit Contents and Functions
Aiming
Your Xenarc X2010 Ford F-150 and Expedition
HID Upgrade Kit headlamps are designed to be
compatible with all mechanical headlamp aiming
devices. It is recommended that the headlamps
be aimed using a mechanical aimer, available at
most automotive repair and body shops or at
many automotive parts stores. Until the Xenarc
X2010 Ford F-150 and Expedition HID Upgrade
Kit headlamps are mechanically aimed, they can
be visually pre-aimed.
Visual Pre-aim
Visual pre-aim requires a Phillips screwdriver
and a measuring tape.
1 On a flat, level surface, park the vehicle 25
feet from a vertical wall with your headlamps
shining on the wall
.
( F I G U R E 5 )
4
ATTACHMENT TERMINALS TO
BATTERY CONTACT BOLTS
ATTACH HARNESS TO
FAN COVER USING 3
CLIPS ON HARNESS
F I G U R E 4
2 Measure the distance from the ground to the
center of the headlamp.
3 Place a piece of tape on the wall at the same
height as the center of your headlamp.
4 With the low beams on, turn the vertical
adjuster with a small crescent wrench until
5
WALL
PLACE TAPE LINE ALONG WALL
AT "X" HEIGHT.
25'
BE SURE VEHICLE IS PARKED ON LEVEL
X
X
GROUND, PERPENDICULAR TO WALL.
X
DISTANCE FROM GROUND TO CENTERLINE OF HEADLAMP.
=
DISTANCE MAY VARY FROM VEHICLE TO VEHICLE DUE TO
TIRE SIZE, SUSPENSION SETUP, ETC.
F I G U R E 5
the bright horizontal line of light at the upper
edge of the beam pattern is just below the
tape on the wall
.
( F I G U R E 6 )
• Pre-aim both sides.
6
F I G U R E 6
5 Turn the horizontal adjuster until the left
edge of the hot spot is at approximately
10 inches to the left of straight-on for
each individual lamp.

Publicidad

Tabla de contenido

Solución de problemas

loading

Productos relacionados para Osram SYLVANIA xenarc X2010

Tabla de contenido