Getting Started - Labelmate LD-100-RS/U Manual Del Usuario

Getting started

9
2
8
3
7
6
• Make sure the Power Switch is in the "OFF" position.
• Set your LD-100/200-RS in place and plug the cord from the Power Supply Module into the Power Input Jack on the
rear of the Unit.
• Connect the Power Supply Module to a suitable power source.
• Place your roll of labels on the Label Roll Holder & slide the Roll Edge Guide(s) to the width of your label web. The Label
Web can be positioned from side to side as required to ensure that the label lines up with the reflective Sensor.
• Remove the first labels to have only the backing paper to attach to the web take-up shaft. Pull the label web under the
1st web guide.
• Thread the label web between the Stripper Bar and the round Guide Rod directly above it.
• Pull the label web under (or over) the second Web Guide and slide the edge guides to the width of the web.
• Pull the paper web above the take-up shaft. Remove the bail and push paper in the bail slot, place the bail back on the
paper to secure it. The prongs of the bail must face the paper in the gap between the vane and the shaft. Turn the CW
to secure it. To remove the paper, turn the bail CCW and remove it.
• Slightly loosen the Label Sensor Lock Knob, until you can just rotate the Sensor. Point the sensor up so it is pointing at
the bottom of the Stripper Bar.
• Place the Power Switch in the "LOW" position. Slowly rotate the Sensor down until the label begins to advance. Continue
to rotate the Sensor slowly until the desired label length is protruding. Retighten the Lock Knob securely.
• Use "HIGH" or "LOW" Switch setting to select the desired speed.
• IMPORTANT – Pull labels UP when removing them. If excess dust or dirt accumulates on the Label Sensor Eye the
Dispenser may not sense labels correctly. Use a cloth or paper towel dampened with water to gently clean the Label
Sensor.
• Do not use any chemicals on the sensor.
• Optional Flanges for the inside and outside of the label roll are available (Order LD-FLANGES. Set of two Flanges). These
Flanges are recommended for narrow or loosely wound labels that may have a tendency to fall off the roll
Labelmate - The World's Leading Manufacturer of Label Dispensers, Rewinders, Unwinders, Slitters & Counting Solutions
1
• 1- media-roll-holder
• 2- web guide-1
• 3- web guide-2
• 4- web take-up shaft
4 5
• 5- bail
• 6- sensor lock
• 7- reflective sensor
• 8- stripper bar
• 9- guide rod
1
9
8
5
4
7
6