Smeg BCC02 Manual De Uso página 19

If the LED (25)
descaling cycle is mandatory to proceed with
further dispensing of drinks.
To carry out a descaling cycle, proceed as
follows:
• Place a container with a capacity of at least
1.4l under the dispenser (11) and the steam
spout (30).
• Make sure that the Primary program with
white illuminated keys is selected.
• Fill the tank (5), up to the "MAX" level, with a
solution of water and descaler in the doses
recommended by the manufacturer.
• With the machine ready for use, press
the keys (20)
simultaneously for at least 3 seconds. The
key (18) flashes with an orange light
and the LED (25)
the entire duration of the descaling cycle,
which has duration of several minutes.
• The descaling cycle ends when the solution
contained in the tank (5) is finished, the key
(18) and the LEDs (21)
(25) light up fixed.
• During the descaling cycle, the machine will
take a few breaks to allow the descaler to
act effectively. Wait for the end of the cycle.
• Pour clean water into the tank (5) up to the
"MAX" level to carry out the rinse cycle, then
press the button (18)
cycle, the button (18)
LED (25) lights up steadily for the entire
duration of the washing cycle.
• When the tank (5) is empty, the rinse cycle
is finished.
• The keys light up in white.
EN - 14
Cleaning and maintenance
flashes, it means that a
and (18)
has a fixed light for
to start the rinse
flashes and the
If, at the end of the descaling
process, the LED (25)
permanently lit, it indicates that
a new descaling cycle must be
carried out since the quantity
of descaling solution that was
used was insufficient for complete
cleaning.
Any other servicing should be
performed by an authorized
service representative.
"Empty system" procedure
The 'Empty system' procedure is recommended
before long periods of non-use and before
consulting a maintenance manager.
• Activate the procedure by holding down
the key (16)
simultaneously for three seconds, the key
(17)
simultaneously.
• The entire quantity of water in the tank is
and
drained through the coffee circuit and the
steam spout.
• The pump continues to operate, even
intermittently, to also empty the internal
water circuits.
• At the end of the procedure the machine
switches off.
The empty system procedure takes
several minutes and on-off cycles.
Do not turn off the machine until the
complete procedure is complete.
and the key (19)
and the key (19)
remains
flash