Sam G-10 Instrucciones página 14

ENGLISH 7
PHASE 12 - MOTORS (DISPLAY: 12 MOTORS):
The test will show the proper functioning of the motors. The test will scan all the motors, so
once inside the test 12 every time the button is pressed, a motor will start.
The sequence starts with everything OFF. Pressing the button:
MOT1: Activates the motor X (right-left)
MOT2: Activates the motor Y (forwards-backwards)
MOT3: Activates the motor Z (up-down)
Exit moving the joystick right or left.
PHASE 13 - COILS (DISPLAY: 13 COILS):
The test will show the proper functioning of the coils. The test will scan all the coils, so
once inside the test 13 every time the button is pressed, a coil will be activated.
The sequence starts with everything OFF. Pressing the button:
BOB1: Activates the coil of the claw (open-closed)
BOB2: Activates the coil of the box (open-closed)
BOB3: Activates the coil of the return (open-closed)
Exit moving the joystick right or left.
PHASE 14- ALARM (DISPLAY: 14 ALARM):
The machine has an electronic TILT system (by default ON).
Enter the test (PRESS BUTTON).
The display shows if it is OFF (deactivated) or ON (activated).
PRESS THE BUTTON for a few seconds to change it.
ON: If during the game the machine receives a hit or is bended, the carriage will move to
the zero point, the game will end and the coin not returned.
OFF: In this mode, the TILT is deactivated and the machine will not cancel the game if it is
hit.
Exit moving the joystick right or left.
PHASE 15- TICKETS (ONLY if SWITCH 2 is ON) (DISPLAY: 1):
SHOWS ONLY WITH PERCENTAGE GAME MODE.
This test shows the number of tickets delivered if no product is obtained, when the ticket
dispenser is installed (by default it will give 1).
Enter the test (PRESS BUTTON), PRESS THE BUTTON successively and the number of
tickets will raise (between 1 and 10).
Exit moving the joystick right or left.