Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Axor Citterio 39210000 Modo De Empleo/Instrucciones De Montaje

6 6 6

Safety Notes

6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.
6 The hot and cold supplies must be of equal pressu-
res.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter) located behind the aerator can be
removed.
• Hansgrohe mixers can be used together with
hydraulically and thermically controlled continuous
flow heaters if the flow pressure is at least 0,15 MPa.
• If the water is flowing along the fixture in the direction
of the shaft, the spray former must be replaced with a
standard air bubbler 13185000.

Technical Data

This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
4
English

Symbol description

®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
Assembly see page 31
Do not use silicone containing acetic acid!
Dimensions (see page 34)

Flow diagram

(see page 34)

with EcoSmart
®

without EcoSmart
®
Spare parts (see page 37)
Operation (see page 33)
Cleaning (see page 36) and
enclosed brochure
Special accessories
special tool (58085000) order as an extra
Installation kit order as an extra
Test certificate (see page 38)