Stacked Iso Din Head Unit Provision - Metra 99-7519B Instrucciones De Instalación

Stacked ISO DIN Head Unit Provision

1. Turn over the 99-7519B housing, take
the climate control and screws removed
from the factory panel and attach the
climate control to the kit housing using
the factory screws. (Figure A)
2 Cut the rib in the middle of the
99-7519B housing to make room for
the DDIN brackets. (Figure A)
3. Slide the appropriate DDIN bracket into
the kit housing. (Figure B)
4. Slide the stacked ISO DIN units into
the DDIN bracket assembly and secure
the units to the kit using the screws
supplied with the head units. (Figure C)
5. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Test the unit for proper
operation.
6. Snap the DDIN trim plate into the
front of the kit housing. Reassemble
dash in reverse order of disassembly.
(Figure C )
Kit Assembly 99-7519B
10
(Figure A)
(Figure B)
(Figure C)