Iso Din Head Unit Provision - Metra 99-5824CH Instrucciones De Instalación

TRANSIT CONNECT 2010-UP

ISO DIN HEAD UNIT PROVISION

Locate the factory wiring harness in
1
the dash. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the unit for proper operation.
2
Mount the ISO Brackets to the head
unit with the screws supplied with
the unit. (Fig. A)
3 Snap the pocket into the bottom
opening of the radio housing. (Fig. B)
4
Slide the head unit into the radio
opening until the side clips engage.
(Fig. C)
5
Snap the Trim plate into the Radio
Housing. (Fig. C)
6 Mount the radio housing assembly
into the sub dash using the supplied
#8 Phillips screws then clip the radio
housing trim panel onto the radio
housing.
99-5824CH KIT ASSEMBLY
A
B
C
3