GYS Tool it PBT 700 Manual De Instrucciones página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Translation of the original instructions
OPERATION AND USE
Note: Whenever the tester is connected to a battery, it will perform a quick check of the cable to ensure proper
connection. If the connection is good, the tester will go to the home screen. If the connection is bad, the display
will show «CHECK TABLE». In this case, check the cable connections. The clamps may need to be reconnected to
the battery or the cable may need to be replaced if its ends are damaged.
1- Ensure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries and systems for 12 & 24 V charging (Only 12 volt for START & STOP batteries)
3- Before running a test on the battery, make sure the ignition is off, the accessories are also off. Close all the
doors and the boot.
4- Recommended operating temperature: From 0°C (32°F) to 50°C (122°F)
5- Make sure the battery terminals are clean. If necessary, clean them using a wire brush.
Any presence of oxidation between the tester terminals and the battery connectors or between the battery
connectors and the battery terminals reduces the effectiveness of the tester.
6- Ensure that there is a CR2032 3V battery in the battery compartment (see diagram below).
Remove the protective
cover
7- Connect the negative (black) terminal to the negative terminal of the battery. Connect the positive plug (red)
to the positive terminal of the battery.
MAIN MENU
Once the clamps are connected, the tester automatically displays the main menu. Use the arrows to scroll
through
the main menu features.
Features
Battery test
System test
Vehicle test
Print the last result
Selection of the language
PBT 700
Remove the compartment
Insert the top of the battery
according to the indicated
polarity (+ or -)
Display screen
BATTERY
TEST
Press "ENTER" to do a battery test
XX.XX V
SYSTEM
Press "ENTER" to test the system
TEST
XX.XX V
VEHICLE
Press "ENTER" to do a vehicle test
TEST
XX.XX V
PRINT
Press "ENTER" to print the last result
THE LAST
RESULT
Press "ENTER" to change the lan-
LANGUAGE
guage
SELECTION
EN
Then press the end.
Close the case.
Action
9

Publicidad

Tabla de contenido
loading

Tabla de contenido