Checks Before Operation; Operation Tips - Tectro TS 226 Instrucciones De Uso

Maintenance
If you plan to idle the unit for a long time, perform the following:
1. Operate the fan for about 6 hours to dry the inside of the unit.
2. Stop the air conditioner and disconnect power. Remove the batteries from the remote controller.
3. The outdoor unit requires periodic maintenance and cleaning. This should only be done by an authori-
zed airconditioning engineer.

Checks before operation

• Check that the wiring is not broken or disconnected.
• Check that the air filter is installed.
• Check if the air outlet or inlet is not blocked after the air conditioner has not been used for a long time.
CAUTION
• Do not touch the metal parts of the unit when removing the filter. Injuries can occur when
handling sharp metal edges.
• Do not use water to clean inside the air conditioner. Exposure to water can destroy the
insulation, leading to possible electric shock.
• When cleaning the unit, first make sure that the power and circuit breaker are turned off.
J

OPERATION TIPS

The following events may occur during normal operation.
1. Protection of the air conditioner.
Compressor protection
• The compressor cannot restart for 3 minutes after it stops.
Anti-cold air
• The unit is designed not to blow cold air on HEAT mode, when the indoor heat exchanger is in one
of the following three situations and the set temperature has not been reached.
A. When heating has just started.
B. Defrosting.
C. Low temperature heating.
Defrosting
• The indoor or outdoor fan stops running when defrosting.
• Frost may be generated on the outdoor unit during heat cycle when outdoor temperature is low and
humidity is high resulting in lower heating efficiency of the air conditioner.
• During this condition air conditioner will stop heating operation periodically and start defrosting
automatically.
4
126
fig. 10