Troubleshooting Tips; Malfunctions And Solutions - Tectro TS 226 Instrucciones De Uso

K
TROUBLE SHOOTING TIPS

Malfunctions and Solutions

G
TROUBLE
Stop the air conditioner immediately if one of the following faults occur. Disconnect the power
and contact your supplier.
• Fuse blows frequently or circuit breaker trips frequently.
• Other objects or water penetrate the air conditioner.
• The remote controller won't work or works abnormally.
• Other abnormal situations.
• Operation indicator flashes 5 times every second, even after mains electricity has been
disconnected and reconnected.
Problem
Unit does not start
Unit is not cooling or
heating room very well
while air flowing out
from the air conditioner
Fan speed cannot be
changed
TEMP. Indicator is not
shown
If the trouble has not been corrected, please contact your supplier. Be sure to inform them of the detailed
malfunctions and unit model.
4
128
Cause
Power cut
Unit may have become unplugged.
Fuse may have blown.
Battery in Remote controller may have been
exhausted.
Distance remote controller to receiver on the
indoor unit is more than 6 to 7 meters, or
there are obstacles in between the remote
controller and the receiver.
The time you have set with timer is incorrect. Wait or cancel timer setting.
Inappropriate temperature setting.
Air filter is blocked.
Doors or windows in room are open.
Air inlet or outlet of indoor or outdoor unit
has been blocked.
Compressor 3 minutes delay protection has
been activated.
Defrosting of outdoor unit being performed.
Air conditioner is in automode
Air conditioner is in dry mode
Air conditioner is in fan mode
Solution
Wait for power to be restored.
Check that plug is securely in wall recepta-
cle.
Replace fuse / reset relay / reset circuitbra-
ker
Replace the battery.
Shorten the distance. Remove possible
obstacles. Aim the remote controller towards
the receiver on the indoor unit.
Set temperature correctly. For detailed
method please refer to "operation with remo-
te control" chapter E.
Clean the air filter.
Close the doors or windows.
Clear obstructions away first, then restart the
unit.
Wait.
Fan speed can only be changed in HEAT,
COOL and FAN mode
Temperature cannot be set in FAN mode