geberit ACO 102 Instrucciones De Servicio página 22

EN
Operation
Inserting Geberit pressing jaws
Prerequisites
Rechargeable battery is not inserted in the pressing tool.
WARNING
Danger of crushing by exposed parts
Do not hold any parts of your body or other objects in between the pressing jaw
Keep your fingers away from the roller range if there is no pressing jaw inserted
CAUTION
Damage to the device because the retaining pin is not pushed in completely
Push the retaining pin in completely and lock it
1
Rotate the retaining pin by 180° to the front and pull it out (see cover page in the front,
figure A).
2
Insert the pressing jaw in the pressing tool (see cover page in the front, figure B).
3
Push the retaining pin in until the stop position is reached and rotate it by 180° to the
rear (see cover page in the front, figure C).
Charging and inserting the Geberit rechargeable battery
CAUTION
Damage to the device due to incorrect rechargeable battery
Make sure that the voltage of the rechargeable battery corresponds to the details
on the specification plate of the pressing tool
Read the user manual for the battery charger for information on how the battery
charger functions.
Remove the rechargeable battery from the pressing tool before transporting and
storing it; otherwise the rechargeable battery will run flat.
1
Charge the rechargeable battery before commissioning.
2
Insert the rechargeable battery in the pressing tool from the rear (see cover page in the
back, figure D).
Result
Pressing tool is in sleep mode. No LED lights up.
22
B1024-003 © 06-2015
965.804.00.0 (02)