geberit ACO 102 Instrucciones De Servicio página 24

EN
Troubleshooting before the pressing sequence
Fault
The pressing tool cannot
be started and no LED
lights up
Green LED flashes
Troubleshooting during the pressing sequence
Fault
Pressing tool stops and
no LED lights up
Red and green LEDs flash
alternately
1) The addresses of authorised repair shops can be requested from the Geberit sales companies or found
at www.geberit.com
Troubleshooting after the pressing sequence
Fault
Red LED lights up
Red LED flashes
Green LED flashes
1) The addresses of authorised repair shops can be requested from the Geberit sales companies or found
at www.geberit.com
24
Cause
Rechargeable battery is
defective
Rechargeable battery is
not inserted
Rechargeable battery not
charged up sufficiently
Cause
Rechargeable battery is
defective
Maintenance interval has
been reached
Cause
A device failure has
occurred
Incorrect or defective
rechargeable battery
inserted
Operating temperature of
the rechargeable battery
has been exceeded or not
attained
Rechargeable battery not
charged up sufficiently
Actions
Have the rechargeable battery
examined by a repair shop and
replace it if necessary
Insert the rechargeable battery
Charge the rechargeable battery
or replace it
Actions
Release start button
Replace the rechargeable battery
and have it examined by a skilled
person
Press unlocking button: roller
drive moves to its starting position
Repeat the pressing operation
Send the pressing tool to an
authorised repair shop for
1)
testing
Actions
Press the start button
If pressing the start button is not
successful, the pressing tool is
defective. Send the pressing tool
to an authorised repair shop for
1)
testing
Check pressing and repeat if
necessary
Replace rechargeable battery
Observe operating temperature of
the rechargeable battery
Charge the rechargeable battery
or replace it
B1024-003 © 06-2015
965.804.00.0 (02)