Maintenance Regulations - geberit ACO 102 Instrucciones De Servicio

Maintenance

Maintenance regulations

For safety reasons, it is absolutely essential to observe the following maintenance
intervals and perform the maintenance work described. The same applies to the
mandatory maintenance rules for the pressing attachments.
A service sticker on the pressing tool indicates the time of the next mandatory
maintenance.
The pressing tool must always be taken for maintenance together with the pressing
attachments in its transport case.
Maintenance work and repair work may only be carried out by Novopress or
authorised Novopress repair shops.
For addresses of authorised repair shops, contact your Geberit sales company or visit
www.geberit.com.
Interval
Regularly (before use,
at the start of the
working day)
Every six months
After 40 000 pressing
operations (interval is
indicated by the red
and green LEDs
flashing) or after two
years at the latest
B1024-003 © 06-2015
965.804.00.0 (02)
Maintenance work
• Examine the pressing tool and rechargeable battery for externally
visible defects and damage that could affect safety
• Clean and lubricate the pressing tool
• Clean pressing attachments and check for defects (particularly
cracks in the material)
• Lubricate pressing attachments; see user manual of the
respective system
• Have an authorised repair shop perform a metrological
measurement in order to establish any safety-related defects or
damage. However, this metrological measurement does not
replace any country-specific regulations and legislation that
might prescribe further checks and maintenance work
• Have an authorised repair shop examine the press capacity and
the state of wear
EN
25