geberit ACO 102 Instrucciones De Servicio página 23

Pressing with Geberit pressing jaws
Prerequisites
• Pipe ends are deburred and clean
• Pipe and pressfitting have been fitted together in accordance with the piping system
installation manual
WARNING
Risk of injury caused by flying fragments if used incorrectly or if worn or damaged
pressing jaws are used
Only use the pressing jaws if they are in perfect working order (see the basic safety
notes)
Make sure that the diameter of the pressfitting matches the diameter of the
pressing jaw
Do not tilt the pressing jaw on the pressfitting
Clean away any dirt, chips or the like between the pressing jaw and the pressfitting
If the pressing jaws have been used incorrectly, or in a way that does not comply
with their intended use, do not continue to use them and have them examined by an
authorised repair shop
Wear suitable protective equipment (protective goggles etc.)
Pressing jaws are wearing parts. Frequent pressing will cause the material to become
worn; advanced stages of wear will be indicated by incipient cracks. Pressing jaws that
display this kind of wear or are damaged in any other way may break, particularly if they
are used incorrectly (e.g. pressing a fitting that is too large, tilting, foreign bodies on
the fitting) or in a way that does not comply with their intended use.
WARNING
Danger of crushing when the pressing tool closes automatically
Do not hold any parts of your body or other objects in between the pressing jaw
Do not hold the pressing tool in the area of the pressing jaw
CAUTION
Damage to the device caused by continuous operation
Allow the pressing tool to cool for at least 15 minutes after 30 minutes of
continuous operation
The procedure for pressing depends on the type of pressing jaw and is described in
detail in the user manual of the relevant system.
1
Make sure that the diameter of the pressfitting matches the diameter of the pressing
jaw.
2
To start the pressing sequence, press and hold the start button for at least one
second.
Result
The hydraulic valve switches off the pressing sequence after the pressing operation
has been completed. The end of the pressing sequence is indicated by the motor
switching off.
B1024-003 © 06-2015
965.804.00.0 (02)
EN
23