geberit ESG 3 Manual De Operación página 43

Fault
<Ready for
welding> LED
display flashes
and <General
malfunction> LED
display lights up
<General
malfunction> LED
display flashes
LED displays for
<Mains
connection>
<Ready for
welding> and
<Welding
complete> light
up, and <General
malfunction> LED
display flashes
1) For addresses of qualified service centres, contact your Geberit sales
company or visit www.geberit.com
B1158-002 © 07-2016
966.473.00.0 (02)
Cause
Too many serial
welding joints
Electrofusion
machine is
defective
Sleeve connection
plugs worn or too
many interruptions
,
from removing the
sleeve connection
plugs during
welding procedure
Actions
Reduce number of
welding joints (refer to
the table on the back
cover page)
Send the electrofusion
machine to a qualified
service centre
Disconnect the mains
plug
Visually inspect the
sleeve connection plugs
and sleeve connection
cables if necessary, or
replace the connecting
cables
Send the electrofusion
machine to a qualified
service centre
EN
1)
1)
43