Malfunctions During Operation - geberit ESG 3 Manual De Operación

EN

Malfunctions during operation

If the <General malfunction> LED display
<General malfunction> LED display
light up, the welding procedure has been aborted prematurely
because of a malfunction.
Fault
LED displays for
<General
malfunction>
and <Mains
connection>
light up
40
Cause
Mains voltage too
low
Mains voltage too
high
lights up, or if the
plus another LED display
Actions
Switch off any non-
essential consumers
Use a power generator
with the correct output
voltage (see chapter
<Operation with power
generator>)
For normal mains
operation, disconnect
the mains plug and
contact your power
supplier
When using a power
generator, ensure the
output voltage is correct
B1158-002 © 07-2016
966.473.00.0 (02)