Uline H-1418 Manual Del Usuario

π
HEAVY-DUTY
WIRE CARTS
TOOL NEEDED
Rubber Mallet
Handle x 2
NOTE: For Three-Shelf Heavy-Duty Wire Cart Units, there will be 3 shelves and 12 sets of shelf supports.
1. Slide top shelf up the posts one end at a time,
handles facing out. (See Figure 1)
2. Snap the interlocking pieces of a shelf support (wide
end down) around the post at the highest groove
where shelf is to be located. Slide the support up or
down until it snaps into the groove.
(See Figure 2)
NOTE: Make sure shelf supports are located
under the shelf.
PAGE 1 OF 3
1-800-295-5510
uline.com
Shelf x 2
Figure 1
CASTER INSTALLATION
Figure 4 1. Make sure post is positioned as shown. (See Figure 4)
2. Engage the wheel brakes to keep casters from spinning during
installation. Use a rubber mallet to tap caster stem into posts.
(See Figure 4)
PARTS
Shelf Support x 8 Sets
ASSEMBLY
3. After snapping together all of the shelf supports
at the proper height, slide the shelf down over the
supports to secure the shelf. (See Figure 3)
4. Repeat steps 1 through 3 to attach the remaining
shelf or shelves in the same manner.
Figure 2
Para Español, vea página 2.
Pour le français, consulter la page 3.
Caster x 4
Figure 3
0221 IH-1418