Uline H-8184 Manual De Usuario página 4

6. Insert leg clamp lock into trapezoid hole on top of
leg clamp. While short end is inserted, using your
foot, step onto the longer end and apply pressure to
snap the lock into place. Repeat for other side.
(See Figure 5)
NOTE: Short end must be inserted first.
NOTE: Arrow on lock must face arrow on clamp.
Figure 5
7. Position stringer in-between adjustable height legs
and align with threaded holes on side of each leg.
Attach stringer to legs using two M8 x 12 mm Allen
bolts for each side. Fasten using 6 mm Allen wrench.
(See Figure 6)
NOTE: Do not tighten all the way because
stringer will be removed at a later step.
NOTE: Protruding end of stringer should be
facing the back side (square edge) of table
top.
Figure 6
Protruding End
PAGE 4 OF 39
ASSEMBLY CONTINUED
8. Fasten cantilevers to tabletop with four 8-15 x 0.625"
tapping screws per cantilever. (See Figure 7)
Figure 7
9. Fasten one additional 8-15 x 0.625" tapping screw to
outside of each adjustable leg cradle. (See Figure 8)
Figure 8
10. Center the assembly onto the workbench top. Using
drill with Phillips head drill bit, fasten assembly to
workbench top with five 8-15 x 0.625" tapping screws
through exposed holes along inner and outer rails.
(See Figure 9)
Figure 9
0920 IH-8184