Uline H-8184 Manual De Usuario página 7

CONTROLS
Up
Button
NOTE: The workbench must be initialized prior
to first use.
• To initialize, press and hold the down button on the
handset until the desk reaches its lowest height,
slightly raises and stops.
• Release the down button. The desk is now ready to use.
NOTE: The desk may need to be reset from
time to time to work properly. Unplug the power
cord for 20 seconds, plug back in and follow
the initialization process to reset desk.
CAUTION! Make sure there are no obstacles in
the desk's height adjustment path, and make
sure the desk is not touching any walls.
CAUTION! Make sure all cords are at the
appropriate length to accommodate changes
in height.
HEIGHT ADJUSTMENT
• Press the up button to raise the desktop.
• Press the down button to lower the desktop.
• Release button to stop movement.
PAGE 7 OF 39
Down Three Preset
Button Position Buttons
OPERATION
Store Position
Button
SETTING HEIGHT ON DISPLAY
• Measure height from floor to top of workbench top.
• Press and hold up and down buttons until dotted
line appears and the numbers re-appear on the
display.
• Use up and down buttons to change the figure to
the actual measured height. Once complete, allow
time for numbers to flash confirming new height.
PROGRAMMING PRESET HEIGHT
• Use up and down buttons to move desk to the
desired position.
• Press the "S" button. The display will flash for two
seconds. Within two seconds, press one of the preset
position buttons and position will be stored.
• The panel will acknowledge by showing "1," "2" or "3"
in the display depending on the chosen preset.
• Up to three preset positions can be programmed.
• Press one of the preset position buttons and the
workbench will start to adjust to the stored position.
Hold the button until the position is reached.
Display
0920 IH-8184