Functional Description - Milwaukee 2678-20 Manual Del Operador

FUNCTIONAL DESCRIPTION

1
11
12
10
8
9
14
11
1. Locking thumb screw
2. Backup release valve
3. Crimping indicator
4. Hanger
5. LEDs
6. ONE-KEY™ indicator
7. Handle
8. Trigger
9. 49-16-BGD3 jaws
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Inserting/Removing the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Always remove battery pack before
WARNING
changing or removing accesso-
ries. Only use accessories specifically recom-
mended for this tool. Others may be hazardous.
Inserting/Removing the Crimping Jaws
1. Remove the battery pack.
2. Remove the locking thumb screw (when used)
from the back of the retaining pin.
3. Push in, then rotate the retaining pin counterclock-
wise 90° . The pin will pop out.
4. Insert the crimping jaws. Line up the center hole
with the retaining pin.
5. Push in the retaining pin, then rotate clockwise
90° .
6. Insert and hand tighten the locking thumb screw.
NOTE: Use the locking thumb screw to prevent the
retaining pin from being unintentionally loosened.
A loose retaining pin may damage the tool.
7. Rotate the jaws to the desired angle.
4
2
13
6
7
5
15
10. Die retaining pins
11. Fixed BG or O
Die bay
12. D3 crimping bay/
die bay
13. Retaining pin
14. 49-16-0OD3 jaws
15. 49-16-00D3 jaws
16. 49-16-KEAR jaws
3
4
16