Homelite UT43103 Manual Del Operador página 21

 When pruning trees it is important not to make
the finishing cut next to the main limb or trunk
until you have cut off the limb further out to
reduce the weight. This prevents stripping the
bark from the main member.
 Underbuck the branch 1/3 through for your first
cut.
 Your second cut should overbuck to drop the
branch off.
 Now make your finishing cut smoothly and
neatly against the main member so the bark will
grow back to seal the wound.
WARNING:
If the limbs to be pruned are above shoulder
height, hire a professional to perform the prun-
ing. Cutting above shoulder height could result
in an accident, causing serious personal injury.
OPERATION
CUTTING SPRINGPOLES
See Figure 25.
A springpole is any log, branch, rooted stump, or
sapling which is bent under tension by other wood
so that it springs back if the wood holding it is cut
or removed. On a fallen tree, a rooted stump has
a high potential of springing back to the upright
position during the bucking cut to separate the log
from the stump. Watch out for springpoles — they
are dangerous.
WARNING:
Springpoles are dangerous and could strike the
operator, causing the operator to lose control
of the chain saw. This could result in severe or
fatal injury to the operator.
Page 21 — English