Cleaning And Storage - HyperIce Vyper 3 Instrucciones De Uso

• Please do not use the Vyper 3, or any high-intensity vibration exercise device
without first consulting with your doctor if any of the following apply: Pregnancy,
diabetes with complications such as neuropathy or retinal damage, wear of pace-
makers, recent surgery, epilepsy or migraines, herniated disks, spondylolisthesis,
spondylolysis, or spondylosis, recent joint replacements, metal pins or plates or
any concerns about your physical health. Frail individuals and children should be
accompanied by an adult when using any vibration device. These contraindications
do not mean that you are not able to use a vibration or exercise device but we do
advise you to consult a doctor first. Ongoing research is being done to the effects
of vibration exercise for specific medical disorders. This will likely result in the
shortening of the list of contraindications as shown above. Practical experience
has shown that integration of a vibrating fitness device into a treatment plan
is beneficial in a number of cases. This must be done on the advice of and in
accompaniment with a doctor, specialist or physiotherapist.
The Vyper 3 should only be charged with the double insulated, 18VDC Hyperice charger
(model number MX24Z2-1801000) that was supplied with the device. Do not charge
the Vyper 3 overnight or leave the Vyper 3 unattended when charging or in use.
The Vyper 3 contains a battery which must be complied with safely at an appropriate
e-waste disposal or recycling facility.
CAUTION
The battery used in this device may present a risk of fire or chemical burn if
mistreated. Do not disassemble, heat above 100 C or incinerate. Dispose of used
battery promptly. Keep away from children. Do not disassemble and do not dispose
of in fire.
SAVE THESE INSTRUCTIONS
The Vyper 3 is a cutting-edge fitness device that uses pressure and high-intensity
vibration to amplify the traditional foam rolling experience. It accelerates warmup and
recovery, releases tension and tightness in the muscles, and helps to maintain full
range of motion while promoting overall wellbeing and performance.
OPERATING
Turn your Vyper 3 ON by pressing the power/speed setting button for three
seconds. Press the power button once to turn device on to speed level one, twice
to turn device to speed level two and three times for speed level three. Pressing
the power button again will turn the device off. The blue LED lights will indicate
the corresponding speed level. The device will turn off after 10 minutes of use. To
continue use, simply press the power button again to the desired level. Turn OFF by
pressing the power/speed setting button for three seconds until all LEDs are off.
CHARGING
Fully charge for up to two hours before first use. For subsequent charges, charge for
two hours, or until the charge indicator lights stop blinking and remain solid lit. To
charge, connect the adapter to the charging port and plug into wall outlet. Device
may be recharged at any time and at any battery level. It is not recommended to fully
deplete the battery to the red LED level. Fully recharge the device monthly to best
prolong battery life. The average runtime is two hours per charge at speed level three,
and longer at lower speed levels. It is recommended to turn the device OFF while the
it is not in use or during storage and travel.

CLEANING AND STORAGE

Make sure the power is OFF and the battery charger is not attached. Use a damp,
clean cloth and gently wipe your Vyper 3. Store in a clean, cool, dry place, out of direct
sunlight, when not in use.
CONNECTING TO THE HYPERICE APP
To connect your device to the Hyperice App via Bluetooth® make sure that your
device is turned on, Bluetooth® is turned on in your phone, and your device is within
close proximity. Select a routine within the Hyperice App and if prompted tap "Scan
for Devices." Select your device when it pops up on the screen. HyperSmart™ will
automatically start your device and adjust the speed and intensity as you follow along
with the routine.