Laser Radiation; Danger Of Tripping - Bosch SMT 300 Manual Original

en 24 | SMT 300 | Safety instructions
¶
Do not allow UltraTraceUV® smoke solution to come
in contact with the eyes.During the filling of the
UltraTraceUV® smoke solution, wear the UV glass-
es provided. However, if the solution nevertheless
comes in contact with the eyes, rinse the eyes with
water (preferably with the aid of an eye wash bottle)
until the irritation lessens.
¶
If you feel unwell, seek medical attention.
3.4

Laser radiation

The laser beam emitted by the
multi-function lamp can blind
individuals, cause accidents,
or damage the eye.
Safety measures:
¶
Do not direct the laser beam toward individuals or
animals, especially the face and eyes, and do not
look directly into the laser beam or its reflection.
¶
If the laser beam strikes an eye, immediately close
your eyes and turn your head away from the light.
¶
Do not make any modifications to the laser equipment.
¶
Supervise children to ensure that they do not play
with the product.
The accessible laser radiation from Class 2 laser equip-
ment lies in the visible region of the spectrum (400 nm
to 700 nm).
The eyelids provide sufficient protection for inadvertent
brief eye contact with such laser radiation. Class 2 laser
equipment may be used without further protective mea-
sures if it is ensured that neither looking directly into
the laser beam intentionally for longer than 0.25 s nor
looking into the laser beam or its reflection repeatedly
is required.
The lid-closure reflex can, for instance, be de-
layed by medications. This poses a particular
risk. Wearing laser safety glasses that provide
protection level R1 is recommended for any-
one who is under the influence of medication.
3.5 Explosion hazard
Possible formation of reactive mixtures during
works on the fuel tank with SMT 300 and
compressed air connection
Safety measure:
¶
During all works on the fuel tank, SMT 300 must
only be connected to an inert gas bottle or an exter-
nal CO bottle
2
|
1 689 989 261 2019-04-08
3.6 Danger of injury, Danger of crushing
If the vehicle is not prevented from rolling
away, there is a danger of people being
crushed against a workbench, for example.
The vehicle has rotating and moving parts
that can injure fingers and arms.
There is the risk with electrically operated
fans in particular that the fan can start
running unexpectedly even when the engine
and ignition are off.
Safety precautions:
¶
Take steps to prevent the vehicle from rolling away
while it is being tested. Select the park position
if the vehicle has an automatic transmission and
apply the handbrake or lock the wheels with chocks
(wedges).
¶
Deactivate the start/stop system when working on a
vehicle in order to prevent uncontrolled engine start.
¶
Operating staff must wear work clothes without
loose bands and loops.
¶
Do not reach in any area with rotating or moving parts.
¶
When working on or in the vicinity of electrically
driven fans, allow the engine to cool down first, then
disconnect the plug of the fan motor.
¶
Route cables at a suitable distance from rotating parts.
¶
Transport and operate the equipment only in
accordance with the operating instructions.
3.7

Danger of tripping

Increased danger of tripping posed by the
smoke supply hose.
Safety measures:
¶
Route the smoke supply hose so as to prevent any
danger of tripping.
Robert Bosch GmbH