Cutting Techniques - BaByliss E840XE Manual Del Usuario

comb guide to double triangle
mark (Fig. 2) and, with the
motor off, pull the guide up to
remove (Fig. 3) it, press the
guide down then turn the dial
to put it on (Fig. 4).
TURNING
USING IT
To adjust the cutting length of
the clipper, turn the dial; the
selected height will appear in
the little window above the
dial.
Switch the ON/OFF button
and select speed I or speed
II. (Fig. 5)
You can change the cutting
length at any time.
NOTE! Make sure you hold
the comb head flat against
the skin. That is, the tips
of the teeth and the little
corners protruding from the
comb should always be in
contact with the skin. If not,
the precision of the cut may
change.
(Fig. 6-7-8)

CUTTING TECHNIQUES

For the beard or moustache
just the way you want it...
Decide on the type of beard
or moustache
suits your face taking into
account the size of your
face and natural growth and
thickness of your beard and/
or moustache. After deciding
on the form of the beard and/
or moustache, it is easy to
IT ON AND
that best
maintain its appearance by
using the trimmer as soon as
you feel it is necessary. For
better results, we recommend
cutting the beard when it is
dry. This helps make the cut
precise and comfortable.
To determine the shape of
the beard
After having combed your
beard in the direction of its
natural growth, decide on
the desired shape by starting
under the jaw. Come back
up each side towards the
ears. Then continue on your
cheeks towards the hair.
Make sure you always trim or
style your beard against the
hair growth.
To thin the moustache,
sideburns,
line...
Place the end of the blade
without comb guide in the
line of the cut desired.
NOTE! Only
opening of the nostrils or ears
to avoid any risk of injury.
MAINTENANCE
For maximum hygiene, the
head of the trimmer can be
washed in water.
NOTE! The
waterproof.
To rinse the trimmer head,
move the comb guide away
from the body of the unit
slightly and run it under water
(Fig. 9). The comb guide can
7
goatee, jaw
use in the
unit is not