Charging The Trimmer - BaByliss E840XE Manual Del Usuario

ENGLISH
E840XE BEARD
MOUSTACHE TRIMMER
1. 1 comb cutting for 30
lengths (from 0.5 to 15mm,
in 0.5mm increments)
2. 2 blades with different
widths: 32mm, to trim the
beard, and 16 mm to style
Movable blade:
- Sharpened using 3D etching
process: for an exceptional
cutting edge
- Long-lasting,
CARBON HLD (Hard Like
Diamond)
hardwearing
stainless steel blade
Fixed blade:
- Titanium
longer life
These two
provide a
and combining
optimally reduces the friction
coefficient.
3. ON/OFF button (2 speeds)
4. Dial for adjusting cutting
length
5. Charging indicator light
6. Charging
stand
7. Plug for using on the
mains and for charging
8. Cleaning brush

CHARGING THE TRIMMER

1. Connect the plug to the
charging stand and plug
into the transformer. Place
the trimmer in the charging
AND
organic
coating: ultra
and 100%
coating:
for
technologies
perfect blade
them
and storage
stand and, before using for
the first time, charge for 16
hours. Ensure the switch
on the trimmer is set to the
OFF position.
2. Make sure the charging
indicator light is on when
the unit is in his stand.
3. A full charge provides a
maximum of 30 minutes'
use of the trimmer.
4. Subsequent
should also be 16 hours.
USE ON THE MAINS
To use the trimmer on the
mains, remove the plug from
the stand and connect it
directly into the unit.
Plug the trimmer, in the OFF
position, into the mains and
switch ON (If the battery
is very weak, wait about 1
minute).
IMPORTANT! Use only the
transformer provided with the
trimmer Ref. E840XE Voltage
= 3V – Tension = 600mA
(Fig.1)
HANDLING
GUIDE
The comb guide is very
practical and guarantees an
even cutting length.
NOTE: Always put the comb
guide on BEFORE turning
the trimmer on, and turn the
trimmer off before removing
it.
To remove or replace the
comb guide, first set the
6
charges
THE COMB