Conceptronic C100S16 Manual Del Usuario página 6

ENGLISH
Desk usage:
• Stick the included rubber feet in each corner to the bottom of the
switch. This will prevent the switch from moving on your desk.
• Place the switch on your desk.
Wall mounted usage:
• Drill two holes into the wall with the same distance as the screw
support holes located on the bottom of the switch.
• Insert screws into the holes in the wall and fasten them with a
screwdriver. Do not screw them completely into the wall: you need
some space to slide the switch onto the screws.
• Gently place the switch onto the wall with the front panel facing up
or down by sliding the screws into the provided slots.
3.2 Connecting the switch
• Connect the power adapter to the DC input of the switch and to a
free wall outlet. All LED's of the switch will blink shortly, indicating
that the switch is starting. When the power LED remains on, the
switch is powered and active.
• Connect your network devices (computer, notebook, printer, router,
etc.) to the LAN ports of the switch. When a connected device is
turned on, the Link/ACT LED of the corresponding port will turn on
and the 100M LED will indicate the connection speed.
Your 10/100 Mbps Ethernet Switch is now
ready to use!
6