Memorising only the
desired stations
You can store up to 6 stations on each band (18
for FM1, FM2 and FM3, 6 for each MW and
LW) in the order of your choice.
1
Press (SOURCE) repeatedly to select the
tuner.
2
Press (MODE) repeatedly to select the
band.
3
Press either side of (SEEK/AMS) to tune
in the station that you want to store on
the number button.
4
Press the desired number button ((1) to
(6)) for two seconds until "MEM"
appears.
The number button indication appears in
the display.
Note
If you try to store another station on the same number
button, the previously stored station will be erased.
Actual total number:
Receiving the memorised
stations
1
Select the desired band (page 6).
2
Press the number button ((1) to (6))
momentarily where the desired station is
stored.
If you cannot tune in a preset
station
Press either side of (SEEK/AMS)
momentarily to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Press either side of (SEEK/AMS)
repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SENS/BTM) momentarily until "LCL" appears in the
display (local seek mode). Only the stations with relatively
strong signals will be tuned in.
Tip
If you know the frequency of the station you want to listen
to, press and hold either side of (SEEK/AMS) for two
seconds until the desired frequency appears (manual
tuning).
If FM stereo reception is poor
— Monaural Mode
Press (SENS/BTM) momentarily until
"MONO" appears.
The sound improves, but becomes
monaural ("ST" disappears).
To go back to the normal mode, press again
until "MONO" disappears.
Changing the displayed items
Each time you press (DSPL), the items
alternate between the frequency and time.
E
Sony CDX-4150RDS (
,S,P,Sw) 3-859-317-12(1)
EN
7