teutonia Cosmo Manual De Instrucciones página 7

Mounting and removing the wheels
Rear wheels:
To detach the rear wheel:
– Press the locking (7) and pull the wheel off the axle.
To attach push the wheel onto the axel.
Check that the wheel is proparly locked by pulling!
Front wheels:
To detach press the locking (10) and pull the steering
axle out. To attach, push the axel into place.
Check that the wheel is proparly locked by pulling!
12
Assembling the wheels
Swivel wheel
Swivel wheel unlocked Swivel wheel locked
We recommend that you do not lock the wheels while
moving as this will give a more comfortable ride.
Seat cover
The seat cover can be removed completely from the
seat unit for washing. Simply open the snaps on the
seat unit.
Attention: When mounting the seat cover, thread the
ends of the 5-point restraint back through the relevant
openings without twisting the straps.
Height adjustable, collapsible handlebar
Press and hold the adjust-
ment buttons on both sides
and adjust the height of the
handlebar to the desired
position.
Applying the Parking Brake
The brake is activated by
pushing down the long
brake lever 1. If it is difficult
to
apply the brake, wheel the
stroller back and forth a
few centimetres so that the
brake bars engage properly
in the wheel rim. Make sure that the brake has locked
securely. You can release the brake by depressing the
brake lever 2.
Attaching and removing the seat or carry-cot
(upper section)
1 1
2 2
4 3
Place the upper section (sports buggy seat or carry-cot)
onto the pram chassis in such a way that the lateral
bars 1 of the upper section click into the slots provid-
ed 2 on each side of the chassis and push the upper
section in as far as it will go. The locks then close
automatically. (The locks must „click" into place.)
WARNING:
Check that the pram body or seat unit attach-
ment devices are correctly engaged before use.
The upper section is secure if the red field in the re-
lease lever is no longer visible. To remove the upper
section press the safety lever (3) up and then the
release lever (4) down until the lever locks. (red field
appears). Then pull the upper section out of the slots
and remove it.
How to use the hood
Push the insert pieces for the hood joints into the
corresponding openings on the armrest or on the
carry-cot.
Attention: You must secure the press studs on the
back end of the cover onto the rear of the backrest
as the cover is also used as a protection against
falling out.
If you need to remove the hood, undo the press studs
on the rear of the backrest; press the release buttons
on the insert pieces of the hood joints and pull the
joints out of the openings. You can open the zip at the
top of the hood for ventilation.
Adjusting the back rest
Pull up on the arrester of
the back rest to change its
inclination angle (4 seating
and prostrate positions +
folding position all the way
forward).
Adjusting the foot rest
Press and hold the foot rest ar-
rester there are three positions
available for the foot rest.
Using the 5-point harness
You can position the shoulder harnesses at 3 levels.
Always use the position closest to the shoulder level
of your child. To open the harness press the central
button on the buckle. To adjust the shoulder/ weist
harness pull the free ends of the strap.
Adjusting the restraints
13