Stanley CUBIX STHT77340 Manual Del Usuario página 10

Applications
Plumb Transfer
• Using the vertical laser beam, establish a vertical
reference plane.
• Position the desired object(s) until they are aligned
with the vertical reference plane to ensure object(s)
are plumb.
Level Transfer
• Using the horizontal laser beam, establish a horizontal
reference plane.
• Position the desired object(s) until they are aligned
with the horizontal reference plane to ensure object(s)
are level.
Square
• Using the vertical and horizontal laser beams, establish
a poing where the two beams cross.
• Position the desired object(s) until they are aligned with
both the vertical and horizontal laser beams to ensure
objects(s) are square.
Manual Mode (See figures
• Disables self-leveling function and allows laser unit to
project a rigid laser beam in any orientation.
10
STHT77340
bix_GB_STHT77340.indd 10
C
Batteries and Power
Battery Installation / Removal (See figure
Laser Tool
• Turn laser tool to battery door and open.
• Install / Remove batteries. Orient batteries correctly
when placing into battery compartment.
• Close battery door. Be sure that the door has been
closed securely.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
)
B
01/07/2013 15:3