Stanley CUBIX STHT77340 Manual Del Usuario página 11

Set Up
Laser Tool
• Place laser tool on a flat, stable surface.
• If using the auto leveling feature move the pendulum
/ transport lock to the unlocked position. The laser tool
must then be positioned in its upright position on a
surface that is within the specified compensation range.
• The laser tool can be placed in any orientation and be
functional only when the pendulum / transport lock is in
the locked position.
Mounting on Accessories
• Position accessory in a place where it will not be easily
disturbed and near the central location of the area to
be measured.
• Set up the accessory as required. Adjust positioning to
be sure accessory base is near horizontal (within laser
tools compensation range).
• Mount the laser tool to the accessory using the
appropriate fastening method to be used with such
accessory / laser tool combination.
CAUTION:
• Do not leave the laser tool unattended on an
NOTE:
• It is best practice to always support laser tool with
one hand when placing or removing laser tool from an
accessory.
• If positioning over a target, partially tighten the fastener,
align laser tool, and then fully tighten.
bix_GB_STHT77340.indd 11
accessory without fully tightening the fastening
screw. Failing to do so may lead to the laser tool
falling and sustaining possible damage.
Operation
NOTE:
• See LED Descriptions for indications during operation.
• Before operating the laser tool always be sure to check the
laser tool for accuracy.
• In Manual Mode, Self-Leveling is OFF. The accuracy of the
beam is not guaranteed to be level.
• Laser tool will indicate when it is out of compensation
range. Reference LED Descriptions. Reposition laser tool to
be closer to level.
• When not in use, please be sure to power OFF the laser
tool and place the pendulum lock in the locked position.
Power
• Move to the locked or unlocked position to turn the
laser tool ON.
• To turn the laser tool OFF, move
position
Modes
Self-Leveling (See figures
C
• The pendulum lock on the laser tool needs to be
switched to the unlocked position to enable self-leveling.
• The laser tool can be used with the pendulum lock
in the locked position when it is required to position
the laser tool at various angles to project non-level
straight lines.
Manual Mode (See figures
• The laser tool can be used with the pendulum lock in the
locked position when it is required to position the laser
tool at various angles to project non-level straight lines.
to the centre
and )
D
and )
C D
11
STHT77340
01/07/2013 15:3