Dometic GROUP WAECO WPS900F Manual Del Usuario página 41

WPS900F/WPS910
8.2 Learning the system
I
NOTE
You must carry out the learning procedure within 4 minutes of
activating the front sensors. Once these 4 minutes have elapsed,
the front system will stop sending an ID code.
The system communicates by radio contact. The control unit must be pro-
grammed to ensure it recognises the codes from the other devices.
See fig. g
Start the programming procedure as follows:
➤ Connect the voltage supply for the front control electronics.
➤ Switch on the ignition.
➤ Engage the reverse gear.
➤ Press the left and right button on the control unit simultaneously for
5 seconds.
✓ The loudspeaker will emit two tones and the red and yellow LEDs will light
up twice.
➤ Let go of the two buttons.
➤ Wait for a high-pitched tone and for the yellow LED to light up.
➤ WPS910 only: Wait for a low-pitched tone and for the red LED to light up.
➤ Wait for the loudspeaker to emit three tones and for the yellow and red
LED to light up three times.
➤ Switch the ignition off.
8.3 Programming the system
I
NOTE
Adapt the programming of the parameters to the type of installa-
tion you have carried out.
You can programme diverse settings.
See fig. h
EN
Setting the system
37