Fitting The Parking Aid - Dometic GROUP WAECO WPS900F Manual Del Usuario

Fitting the parking aid

4.3 Painting the sensors
See fig. 6
I
NOTE
The sensors may be painted. The manufacturer recommends
having the sensors painted by a specialist workshop.
5 Fitting the parking aid
A
NOTICE!
On vehicles which feature metal reinforcement behind the bump-
ers, the sensors must not be touching this reinforcement. Other-
wise there is no guarantee the parking aid will function correctly.
See fig. 7 to fig. b
Supplements fig. 8
A
NOTICE! Risk of malfunction!
Align and attach the sensor holders correctly. Otherwise there is
no guarantee the parking aid will function correctly.
The sensor holders must be attached with the retaining tabs point-
ing up and down.
➤ Clean the adhesive surface on the inner side of the bumper with a primer.
➤ Apply a small amount of grease inside the sensor plug connections.
Supplements fig. a
Both the control electronics have been configured for front sensors by
default. Define the control electronics for the rear sensors as follows:
➤ Disconnect the cable bridges.
32
WPS900F/WPS910
EN