Ec Declaration Of Conformity - BLACK&DECKER KA175 Manual De Instrucciones

VARIABLE SPEED (KA185E/KA186E)
The variable speed control on the front of your sander
gives the optimum speed for every material.
Suggested speeds are given in the following table:
Material
Hardwood (beech)
Softwood (pine)
Veneer wood
Synthetic material
Acrylic glass
Non-ferrous metal
Steel
Lacquer removal
OPERATING YOUR SANDER
KA175/KA273
KA180/KA185/KA185E/KA186/KA186E/374455
To switch your sander on, press the switch marked "1".
To switch your sander off, press the switch marked "O".
Slide the cover of the
dust extraction outlet
forward and insert the
nozzle of the dust
extraction bag in the
aperture. To empty the
dust extraction bag, open
the zip fastener and
empty the contents.
To remove the dust
extraction bag, depress
the release catch and
remove the bag from the
aperture.
To adjust the speed of
your sander, set the
control knob to the
desired number.
Electronic level
3-5
3-5
2-4
3-4
2-5
2-5
2-5
3-5
To switch your sander
on, slide the on/off
switch forward; the
mark "1" appears.
To switch your sander
off, slide the on/off
switch to the rear; the
mark "O" appears.
HANDY HINTS
• Use the correct grade of sandpaper. Low grit
sandpapers give a high stock removal rate, with a
coarse finish. High grit sandpapers give a low stock
removal rate, with a finer finish. As a general rule,
start with the low grit paper and finish with the
higher grit.
• Replace worn sandpaper.
• Empty the dustbag (KA273) every 10 minutes.
• Set the correct speed (KA185E/KA186E). Use low
speed for acrylics and synthetics and use medium
or high speed for hard and soft wood.
TOOL CARE
• Do not apply excessive pressure on your sander. This
can cause your sander to overheat. If your sander
becomes too hot, operate it off-load for 2 minutes.
• Always keep the air cooling vents on the motor
housing clear.
• To clean your sander, proceed as follows:
• Disconnect the plug from the electricity supply.
• Use a clean dry paint brush to clear vents and ducts.
• Clean the housing using a clean damp cloth (do not
use solvents, petrol or turpentine).

EC DECLARATION OF CONFORMITY

We declare that units: KA175, KA180, KA185, KA185E,
KA186, KA186E, KA273, 374455 conform to
89/392/EEC, 89/336/EEC, EN55014, 73/23/EEC, EN55104,
EN50144, EN6100
A weighted sound pressure 85dB (A)
A weighted sound power 98dB (A)
Hand/arm weighted vibration 4.6m/s
Brian Cooke - Director of Engineering
Black & Decker, Spennymoor, Co Durham DL16 6JG UK
The Black & Decker policy is one of continuous improve-
ment to our product and as such we reserve the right to
change the product specification without prior notice.
ENGLISH
Always hold your
sander with two hands.
Always sand with the
grain of the wood. If you
sand across the grain,
you will leave swirl marks.
2
25