Braun MultiQuick 9 MQ9137XI Manual De Instrucciones página 19

Pilot light Appliance / Operating status
Safety button Appliance is ready for use.
light Flashing red
Safety button Appliance is released (switch
light off release button is pressed) and
can be switched on.
Standby mode Device is active again if any
after 10 minutes. button is pressed
All lights switch
off.
Safety button light Device is overheated. Let the
solid red and device cool down one hour. It
imode selector is ready for use again when
lights are all the imode selector light stops
flashing flashing and the safety button
light flashes.
ActiveBlade Shaft (B)
The hand blender is equipped with an ActiveBlade
shaft, which enables the knife extend to the bottom
of the bell. The adjustment is made automatically by
pressure required in blending tasks, especially
suited to mix hard foods e.g. raw fruits and
vegetables.
It is also perfectly suited for preparing dips, sauces,
salad dressings, soups, baby food, as well as
drinks, smoothies and milkshakes.
For best results, use the highest speed.
Assembly and Operation
• Attach the ActiveBlade shaft (6) to the motor part
until it clicks.
• Place the ActiveBlade shaft into the mixture to be
blended. Then switch the appliance on as
described above.
• Blend ingredients to the desired consistency
using a gentle up-and-down motion.
Depending on the pressure applied, the
ActiveBlade shaft will depress and blade will
extend.
• After use, unplug the hand blender and press the
EasyClick Plus release buttons (5) to detach the
ActiveBlade shaft.
Caution
• Do not let liquids or ingredients overlap the green
line of the ActiveBlade shaft.
• If using the appliance to purée hot food in a
saucepan or pot, remove the saucepan or pot
from the heat source and ensure the liquid is not
boiling. Allow hot food to cool slightly to avoid
risk of scalding.
• Do not let the hand blender sit in a hot pan on the
cooktop when not in use.
5722114494_HB901-MQ9137XI-9199XL_USCA.indd 19 5722114494_HB901-MQ9137XI-9199XL_USCA.indd 19
• Do not scratch the ActiveBlade shaft over the
bottom of pans and pots.
Recipe Example: Mayonnaise
1.25 cups / 250 g oil (e.g. sunflower oil)
1 egg and 1 extra egg yolk
1–2 tbsp. Vinegar
Salt and pepper to taste
• Place all ingredients (at room temperature) into
the beaker in the order as above.
• Place the ActiveBlade shaft at the bottom of the
beaker. Blend at maximum speed until the oil
starts emulsifying.
• With theActiveBlade shaft still running, slowly
raise the shaft to the top of the mixture and back
down to incorporate the rest of the oil.
NOTE: Processing time: approx. 1 minute for
salads and up to 2 minutes for a thicker
mayonnaise (e.g. for dip).
Whisk Accessory (B)
Use the whisk only for whipping cream, beating egg
whites, making sponge cakes and ready-mix
desserts.
Assembly and Operation
• Attach the whisk (8b) to the gearbox (8a).
• Align the motor part with the assembled whisk
accessory and push the pieces together until
they click.
• After use, unplug and press the EasyClick Plus
release buttons to detach the motor part. Then
pull the whisk out of the gearbox.
Tips for Best Results
• Move the whisk clockwise while holding it at a
slight incline.
• To prevent splattering, start slowly and use the
whisk accessory in deep containers or pans.
• Place the whisk in a bowl and only then switch
the appliance on.
• Always ensure the whisk and mixing bowl are
completely clean and free of fat before whisking
egg whites. Only whip up to 4 egg whites.
Recipe Example: Whipped Cream
1.8 cups / 400 ml chilled cream (min. 30% fat
content, 4 - 8 °C)
• Start with low speed (light pressure on the
Smartspeed switch) and increase the speed
(more pressure on Smartspeed switch) while
whipping.
• Always use fresh chilled cream to achieve greater
and more stable volume when whisking.
Puree Accessory (C)
The puree accessory can be used to mash cooked
vegetables and fruits such as potatoes, sweet
potatoes, tomatoes, plums and apples.
19
01.04.21 08:56 01.04.21 08:56