Using Geneo Personal; The Geneo Personal Device; Led Indicators; Daily Facial Cleansing - POLLOGEN Geneo Personal Manual Del Usuario

10

USING GENEO PERSONAL

THE GENEO PERSONAL DEVICE

The Geneo Personal device is used to cleanse the skin. It can also be used as an applicator
for a weekly treatment using Geneo Personal skincare products, as described on page 12.
Capsule Eject Button
LED Indicator
Front of the
FIG.3
Geneo Personal device

LED INDICATORS

The LED indicator on the front of the Geneo Personal device indicates the current
state of the battery.
Note - You can plug in the USB connector before or after placing the device in its
cradle for charging.
LED COLOR
• Blinking green
• Steady green
• Blinking yellow
•
Steady yellow
Tip - To insure that the device is always ready for use it is recommended to keep it
fully charged in the charging cradle between uses.
Brush/Capsule Holder
Power Button
Back of the
FIG.4
Geneo Personal device
INDICATOR STATE
Battery Charging
Battery Full
Battery Low
Battery Depleted

DAILY FACIAL CLEANSING

Cleanse your face daily using the Geneo Personal device in order to refresh and enhance
your skin's appearance.
Before You Begin
Before using the Geneo Personal for the first time, charge the device so that its battery
is fully charged and its LED indicator is steady green, as described on page 10.
To cleanse your skin with the Geneo Personal
1. Attach the cleansing brush to the device by pushing it into its holder, as shown in FIG.5.
2. Remove all makeup from your face.
3. Wet your face and apply a generous amount of your regular cleansing soap.
4. Turn on the device by pressing the Power button once on the back of the device,
which is located directly beneath the brush, as shown in FIG.4. You do not need
to hold down the button. The device will begin to vibrate.
5. Move the device in small circular motions all over your face, as shown in FIG.6. We
recommend cleansing your face for at least 3 minutes. After 3 minutes of usage, the
device will alter its vibrations to indicate the end of recommended treatment time.
6. Turn the device off by pressing the Power button once.
7. After cleansing your face, rinse your face with lukewarm water.
8. Generously apply the Geneo Personal Cream provided in the Facial Treatment kit
on your face.
9. Disconnect the brush from the device by gently pulling it out.
10. Rinse the brush under running lukewarm water and then dry it with a dry cloth.
11. Clean the device with a moist cloth, towel or wet wipe, or by rinsing it under
running water.
Tip - It is recommended to use the original Geneo Personal consumables for best results.
FIG.5 Attaching the Brush
11
FIG.6 Cleansing Motion on the Face
Warning - Do not treat your eye area
with the device