Kohler K-697 Guia De Instalacion página 11

Cold
4. Bath and Shower Valve Installation
IMPORTANT! The valve must be installed with the open port on
the bottom of the valve. Use a double ell at the bath spout location
and run the shower piping up from there.
Flush the hot and cold water supply lines to remove any debris.
Use thread sealant and connect the hot and cold water supply
lines to the valve inlet ports.
NOTE: If the existing hot and cold plumbing is reversed, go to the
"Reversed Inlet Supplies" section.
Connect the water outlet lines to the valve ports.
IMPORTANT! Secure the piping to the framing.
IMPORTANT! Secure the valve to the framing in 2x6 installations.
Install the bath spout nipple and showerhead nipple following
the directions included with the trim.
Go to the "Rotate the Cartridge" section and follow the directions
there.
Kohler Co.
Hot
11 1066046-2-B